At present, these two data have been published in Jining, Sichuan and Linyi, Shandong.
Therefore, the safety injection pass rate of 202 1 can only be estimated by the data of Sichuan and Shandong.
Sichuan = 2933-32337 = 9.07%
Shandong Linyi =450÷3659= 12.30%
Jining, Shandong =367÷7203=5. 10%
According to the data released by Sichuan and Shandong, the pass rate is basically maintained at 8%- 13% this year, and the pass rate is low in a few cities in Sichuan.
The pass rate of 20 19 safety injection before the reform was relatively high, and the number of applicants increased year by year, as shown in the following table. Among them, the highest pass rate of safety injector examination was in 2008, reaching 54.39%, and the lowest was 20 17 years, reaching 17.3%. The passing rate of 19 and 20 years basically fluctuates between 10% and 15%.
It is not difficult to see from the above figure that the passing rate of intermediate safety engineers starts from 20 1 1, and it shows a downward trend every year, but the annual difference is not particularly large. Why is there such a trend?
First of all, although the number of applicants for safety engineers is increasing year by year, the talent gap is still very large, showing a state of short supply. According to Professor Song, director of the Risk Management Institute of Beijing Jiaotong University, the demand for registered safety engineers is conservatively estimated to be around one million in the next five years, but now the number of applicants per year is only 1 10,000. Therefore, the country should not greatly reduce the pass rate of the safety injection test.
Secondly, judging from the difficulty of the exam, the pass rate of the exam card is different every year, which shows that the country is balancing the pass rate of the safety exam.