Current location - Education and Training Encyclopedia - Educational Knowledge - Matters needing attention in aerial work
Matters needing attention in aerial work
Precautions for aerial work are as follows:

1. Scaffolds, platforms, ladders, protective fences, pedals, safety belts and safety nets should be used for aerial work. Before operation, carefully check the firmness and reliability of the safety equipment used.

2, all personnel engaged in aerial work should accept the education of aerial work safety knowledge. Special aerial work personnel should hold relevant certificates and make special safety technical disclosure according to relevant regulations before taking up their posts.

3, aerial work personnel should undergo a medical examination, qualified rear can mount guard. Operators must wear and use protective articles such as safety helmet and safety belt correctly according to regulations.

4. All kinds of safety warning signs must be hung on the corresponding parts of the construction site at the aerial work site, and a red light should be set to warn at night.

5. It is forbidden to throw tools and materials used in aerial work.

6, aerial work should be set up reliable escalator, homework personnel should be up and down along the escalator, not climbing along the vertical pole and railing.

7. Anti-skid measures should be taken in rainy and snowy days. When the wind speed is above10.8m/s, and under the climatic conditions such as lightning, rainstorm and fog, open-air aerial work is not allowed.

8, before aerial work, should organize the relevant departments to acceptance of safety protection facilities, experience qualified signature rear can work. When it is necessary to temporarily dismantle or change the safety facilities, it shall be approved and signed by the principal responsible person, and the relevant departments shall be organized for acceptance. It can be implemented only after passing the acceptance.

9, found that there are hidden dangers in safety measures, take immediate measures to eliminate hidden dangers, stop operation when necessary.

10. When encountering all kinds of bad weather, all kinds of safety facilities must be inspected, corrected and maintained to make them perfect.

1 1. Frost, water and snow must be removed from the site.

12, the seat belt should be hung high and used low to prevent swinging and collision, and all parts of the seat belt should not be disassembled at will. If the appearance of the seat belt is damaged or an odor is found, it should be replaced immediately.