A painting and calligraphy mounting and edging device comprises a shell, an iron block, a heating rod, a bracket and a bearing, wherein the shell is rectangular, the upper surface of the shell is provided with a rectangular groove, the outer side of the shell is provided with a circular through hole communicated with the rectangular groove, and the iron block is arranged in the rectangular groove in a rectangular shape.
One side of the iron block is provided with a round hole, and the round hole is coaxial with the round through hole on the side of the shell; The heating rod is inserted into the circular hole on the iron block through the circular through hole on the side of the shell; The upper surface of the leakage part of the iron block is provided with a groove; Two brackets are arranged below the shell; The bearing is installed between two brackets through a round rod.
The utility model has the advantages of simple structure and convenient use. The edge paper tape is installed on the bearing, and the bearing is detachable, which is convenient for replacing the edge paper tape. By fixing the orientation of the fence, the mounting and wrapping of calligraphy and painting can be effectively completed, and the work efficiency is improved.
How to use a small edge device for painting and calligraphy mounting;
Remove the release paper from the cut loose paper, put the mounting piece on the mounting table with its front face up, and iron the edge in the same way as the fillet, the width of which is half that of the paper. After ironing both sides of the wrapping paper, turn the mounting piece upside down for trimming. You can cut a 6cm square release paper and put half of it under the mounting sheet.
Fold the other half in half, flush with the edge of the mounting sheet, hold the release paper with the thumb and forefinger of the left hand, and hold the mounting sheet with the other three fingers, and use it gently until the wrapping paper is folded in half and taken out. In this way, the irons held by the left hand and the right hand cooperate with each other and iron them while holding them until the two wrapping papers are ironed. After wrapping, put it into the machine for hot pressing for about 10 second, take it out and lay it flat on the installation platform, and prepare the pole.