CP 1025 is an entry-level color laser printer. The model of toner cartridge used is CE3 10A-CE 3 13a. Take CE 3 10a as an example to introduce the powder adding process.

First, put the compact flat. Because cp 1025 is separated from the drum powder, it is very simple to add powder to CP 1025.

Unscrew the two screws of the white clip with a screwdriver.

Take off the white clip.

Remove the developing roller (magnetic roller).

Remove the scraper fixing screw with a screwdriver.

Remove the scraper and clean it, leaving the toner in the toner box.

Inject specially added toner into the toner cartridge.

Clean the developing blade, especially pay attention to the scale generated by the blade of the cleaning blade, otherwise it will affect the printing effect.

Then replace the developing blade and fix it with screws.

Clean the developing stick, if possible, with alcohol.

The driving gear and the developing rod are installed at the same time, and the white gear is sleeved on the developing roller.

Install the white clip and fix it with screws.

Finally, replace the counting chip as shown in the figure.

After all the work is finished, try to turn the magnetic roller drive gear by hand to see if the powder is evenly spread. If it is not uniform, it can be appropriate

Adjust the position of the wiper blade.

You can pay attention to Weibo, the official of our Q&A Hall, and participate in the discussion of more questions. Click Weibo on the right.

For more questions about the use of printers, you can post in the forum for real-time discussion:

Zhongguancun Online-Office Forum

I hope the above information is helpful to you.