1. Personnel without pre-job safety training shall not operate the injection molding machine;

2, boot personnel must ensure energetic, it is strictly prohibited to operate the injection molding machine in spite of illness or drunk;

3, unauthorized personnel, it is forbidden to bring blades, nozzle scissors and other hardware objects into the mold cavity to work, to prevent the occurrence of mold damage;

4. It is forbidden to charge mobile phones and other electrical appliances in the power socket of the injection molding machine;

5. Before starting the machine, check whether the safety devices such as the switch of the safety door at the front and rear of the injection molding machine platform and the "emergency stop" button are normal, whether there are obvious defects in various parts of the machine, and then start the machine after confirming that it is normal;

6. It is forbidden to use the limit switch of the rope safety door, to connect the safety device of the machine circuit by short circuit with wires, and to lift the mechanical safety lock with any object to release the safety protection device of the injection molding machine and start the operation, so as to prevent the personal safety accident of the starter when the machine fails;

7. When each set of molds is installed on the machine for production, it is necessary to adjust the mechanical safety position (the clearance is about 30mm-50mm). When the safety door is opened, it is necessary to ensure that the safety stop can effectively block the safety rod of the injection molding machine to prevent the occurrence of industrial accidents;

8. The starter shall not lean on the mechanical moving parts of the injection molding machine, and must hit the front safety door when starting to take products. It is forbidden to take products from the back door and security door;

9. Wear necessary labor protection articles (safety helmet, gas mask, earplugs, dust-proof glasses, heat-insulating gloves, etc.). ) according to the safety requirements, and put away sharp tools to prevent accidental injury to others or yourself;

10. If the injection molding machine needs to replace the accessories of the safety system device, it must notify the equipment engineering maintenance personnel to replace them, and notify the relevant person in charge of the workshop;

1 1. In the process of production and operation of injection molding machine, if the machine or mold is abnormal, you should immediately press the "emergency stop" switch and notify the technician or monitor to handle it. Unauthorized adjustment and maintenance are strictly prohibited.