Methods/steps

1

Open the original image to enlarge. The original picture is not very clear, so the first step begins to shape. ?

Draw a path along the upper eyelid with the pen tool, as shown in the figure, and then select the deepening tool. Here is a trick: first, deepen the simulated pressure with a small value unchecked, and then deepen the simulated pressure with a large value checked, so that the transition will be more natural.

The lower eyelid is treated in the same way as the upper eyelid, thus completing the most basic outline of the eye. ?

Then use the deepening tool to adjust the middle tone and deepen the end of the eye. The deepening value should not be too large, and the effects after deepening are as follows

Select the Oval Marquee Tool, circle the eyes and deepen them with highlights. I pushed too hard and turned black all over. Just deepen it properly, and pay attention to the handover of eyes and upper and lower eyelids. The exposed eye is not a complete circle.

After the eyeball deepens, use the lasso tool to select the white part of the eye, feather 2 pixels, and brighten it with a curve. When selecting a lasso, hold down the Shift key to select multiple unconnected areas.

Create a new layer, use a brush to select some beautiful colors to draw the iris and reflection, cooperate with the deepening and lightening tools to deal with the light and shade, and then use the smudge tool to draw the darkest pupil in the middle. I wiped it again, that's all.

Similarly, create a new layer and draw the brightest white reflection. You can use the smear tool to take the edge of the blunt place, but not all of it. If the highlight is empty, the eyes will not gather. Use a bright highlight tone with a value of about 10-20 to brighten the corner of the lower eyelid.

Let's draw an eyelid and use the pen tool to draw a path along the position of the double eyelid in the original picture (imagine it yourself if the original picture is a single eyelid). I used 3 pixels here to deepen it. It should be noted that when tracing the path, do not check the simulated pressure, and use the blur tool or smear tool to deal with the unnatural places at both ends. If the simulated pressure is checked, the deepened double eyelids will be much shorter than the original path.

There are many ways to draw eyelashes. Here, we will use common and safer methods. After drawing the path, press F5 to set the brush, as shown in the figure, and then create a new layer to stroke the path with brown or a color slightly lighter than black. The lower eyelashes are usually shallower than the upper eyelashes. Just use a low transparency eraser.

For the part of lacrimal gland, I directly chose the part with brighter skin and clicked a spot with a brush to be lazy. By the way, I adjusted my dark complexion.

Finally, I made a little skin, hair and eyebrows to print my eyes!