How to pass the "one" stoker certificate

Call the local area

Bureau, they are the competent department, responsible for certification.

< 2 > What are the requirements for boiler technicians?

According to the provisions of the General Administration of Quality Supervision, Inspection and Quarantine (SIQQ [2001] No.38) on the assessment and management of boiler firemen, firemen are divided into four categories. The boiler is allowed to run. ⅰ steam boiler; Hot water boiler; Organic heat carrier furnace. Type Ⅱ steam boiler with working pressure less than or equal to 3.8 MPa; Hot water boiler; Organic heat carrier furnace.

Because the boiler is a device with explosion hazard, operators are required to undergo safety technical training and assessment, and obtain a fireman's post certificate issued by a safety supervision institution at or above the municipal level or an authorized county-level safety supervision institution before being allowed to operate the corresponding type of boiler independently.

(2) The initial examination of the fireman's certificate is either conditional extended reading:

To be a fireman, you should have the following basic qualities and skills.

Before starting the boiler, check and prepare relevant equipment. Confirm that all kinds of auxiliary equipment are in good condition before ignition. When the cold boiler is heated evenly, increasing the firepower makes the boiler pressure rise gradually, which is called the opening pressure. At this point, the boiler enters the normal operation state.

During the operation of the boiler, attention should be paid to keeping the pressure and water level within the normal range and adjusting them according to the actual use of heat energy. When the thermal energy output cut-off door is closed, it is necessary to suppress the fire or stop the furnace.

The daily adjustment and maintenance of boilers, the operation and maintenance of various auxiliary machines and safety accessories are all within the scope of the fireman's work. In addition, it is necessary to do a good job in boiler operation records and the prevention and treatment of general accidents.

"3" Self-study Examination Fireman Certificate

The stoker certificate is the boiler certificate, which is called differently. The source boiler certificate is generally handled in the local quality supervision bureau or safety supervision bureau. According to Article 4 of TSG G600 1-2009 "Assessment Outline for Boiler Safety Managers and Operators", boiler operators refer to those who are engaged in the operation of boilers in use by boiler users. Boiler operators are divided into Grade One, Grade Two and Grade Three, and their work scope is as follows: (1) Grade One, steam boilers with rated working pressure less than or equal to 0.4MPa and rated evaporation less than or equal to 0.5t/h, hot water boilers with rated power less than or equal to 0.7MW and organic heat carrier boilers; (2) Class II steam boilers with rated working pressure less than 3.8MPa, hot water boilers and organic heat carrier boilers; (3) Class III steam boilers with rated working pressure greater than or equal to 3.8MPa Note1:Class III boiler operators can serve as Class II and Class I boiler operators, and Class II boiler operators can serve as Class I boiler operators. Note 2: It is suitable for boiler operators who apply for a single boiler type (such as organic heat carrier boiler, vertical hand-fired boiler, waste heat boiler, oil field steam injection boiler, etc.). ), the assessment content can be focused, and the scope of boiler types can be limited in the certificate of special equipment operators. Note 3: For special equipment operators, the qualification items in the certificate of special equipment operators can be marked with their grades, which are indicated as Grade III (advanced), Grade II (intermediate) and Grade I (primary) respectively.

What are the requirements for boiler certificate examination?

According to the General Administration of Quality Supervision, Inspection and Quarantine (General Administration of Quality Supervision, Inspection and Quarantine [20065438+0] No.38), the stoker capacity is divided into four categories.

kind

Permitted boiler

ⅰ steam boiler; Hot water boiler; Organic heat carrier furnace

Type Ⅱ steam boiler with working pressure less than or equal to 3.8 MPa; Hot water boiler; Organic heat carrier furnace

Type ⅲ steam boiler with working pressure less than or equal to 1.6 1MPa; Hot water boiler with rated power less than or equal to 7MW; Organic heat carrier furnace

Ⅳ. Steam boilers with working pressure less than or equal to 0.4 MPa and rated evaporation less than or equal to 1t/h; Hot water boiler with rated power less than or equal to 0.7 MW

Assistant engineers, engineers and technicians are the technical titles of technicians.

Technicians and senior technicians are the technical levels of workers.

How does "Wu" test the boiler certificate? What are the steps?

There are two parts in the test boiler copy: attack 1. Theoretical knowledge department. 2. The actual operation department.

First, the assessment content of theoretical knowledge group.

1. Need to know the basic knowledge and characteristics of pressure, temperature, medium, fuel, combustion, heat transfer, water circulation and various boiler structures.

2. Notes on "Function", "Structure", "Principle and Ensuring Sensitivity" of Boiler Safety Accessories.

3. Precautions for "Thermal Instrument", "Automatic Interlocking Protection Function" and "Operation Required by Maintenance Management".

4. Understand the boiler water treatment, combustion, ventilation, slag removal, soot blowing, smoke and dust removal and other auxiliary equipment as well as the structural characteristics, functions and operating essentials of the circulation system.

5. Key points of boiler operation management.

6. Understand boiler accidents and learn to prevent and deal with them.

7. Precautions for boiler shutdown maintenance.

8. Understand the boiler safety regulations, use registration, installation, inspection, repair and transformation, accident reporting and handling, operation management and other rules and regulations.

2. The actual operation department assessment content.

What needs to be done before the boiler starts is: preparation, ignition, boosting, operation, adjustment, fire extinguishing, shutdown and other operations.

2. Inspection, maintenance and adjustment of boiler safety accessories.

3. Maintain and operate all kinds of auxiliary machines and equipment.

4. Accident simulation exercise.

How to pass the "Lu" stoker certificate?

First or second class, operation certificate or grade certificate. Our school has these projects to report.

Is there an age requirement for taking the boiler certificate?

1. Requirements: At least 18 years old, male age is not more than 60 years old and female age is not more than 55 years old. They have a junior high school education or above, and there are no diseases or physical defects that hinder the operation of the furnace.

2. Registration materials: Take two photos of 1 inch, register with the local technical supervision bureau, pay tuition fees around 300 yuan, take the study exam, and obtain the operation certificate of special equipment operators after passing the exam. The certificate shall be valid for 4 years.

3. Generally, there are two kinds of exams to obtain the special type of work certificate of the social security department skill appraisal center. One is the vocational skills knowledge test, and the other is the training test, but it should not be too difficult.

Can I take the boiler certificate with junior high school education?

Yes, this is the fireman's certificate. To take the exam, the special office of the provincial quality supervision bureau or similar organs of the municipal special equipment administration have training for special equipment operators!

How many grades of "nine" stoker certificate is better to test?

The stoker certificate is the boiler certificate, which refers to different sources. Boiler certificate is generally handled in the local quality supervision bureau or safety supervision bureau.

According to TSG

Article 4 of G600 1-2009 Examination Outline for Boiler Safety Managers and Operators stipulates that boiler operators refer to those who are engaged in the operation of boilers in use by boiler users.

Boiler operators are divided into level one, level two and level three, and their work scope is as follows:

(1) Class I steam boilers with rated working pressure less than or equal to 0.4 MPa and rated evaporation less than or equal to 0.5t/h, as well as hot water boilers and organic heat carrier boilers with rated power less than or equal to 0.7 MW;

(2) Class II steam boilers with rated working pressure less than 3.8MPa, hot water boilers and organic heat carrier boilers;

(3) Class III steam boilers with rated working pressure greater than or equal to 3.8 MPa.

Note 1: the tertiary boiler operator can be the secondary and primary boiler operator, and the secondary boiler operator can be the primary boiler operator.

Note 2: It is suitable for boiler operators who apply for a single boiler type (such as organic heat carrier boiler, vertical hand-fired boiler, waste heat boiler, oil field steam injection boiler, etc.). ), the assessment content can be focused, and the scope of boiler types can be limited in the certificate of special equipment operators.

Note 3: For special equipment operators, the qualification items in the certificate of special equipment operators can be marked with their grades, which are indicated as Grade III (advanced), Grade II (intermediate) and Grade I (primary) respectively.

How to test the operation certificate of "receiving" firefighters

The fireman is the abbreviation of boiler fireman, and the source is the specialized personnel who operate special equipment such as boilers.

The certificate of special equipment operators issued by the Bureau of Quality and Technical Supervision is a necessary certificate for engaging in related technical work. The training is divided into two parts: evidence collection and review. The request for review shall be made within four years from the date of issuance of the certificate, usually two to three months before the expiration of the certificate review.

1. Registration materials: copy of ID card 1 copy, copy of education (diploma or household registration book) 1 copy, and 4 2-inch color photos on a white background. When the company is registered, it needs to stamp the safety education and internship certificate.

Registration conditions: junior high school education or above, good health, male no more than 60 years old, female no more than 55 years old.

Cost: 750 yuan (including all costs of training and evidence collection) Appraisal cost: 350 yuan.

2. Training content: basic knowledge of gas boiler, gas and its combustion, basic structure of gas boiler body, safety technology of changing coal-fired boiler into gas, burner for boiler, accessories of gas boiler, automatic control principle and ignition procedure, operating rules and troubleshooting of gas boiler, program controller and burner control, pressure, temperature, flame sensor and its control, water level sensor and water level control, etc.

3. Inspection date: once a month.

4. Date of issuance: one and a half months after the examination.

Issuing Authority: * * Provincial Bureau of Quality and Technical Supervision