Operating rules of injection molding machine: \x0d\ 1. Job preparation \x0d\ 1. Check the raw material supply of the feeding system \x0d\2. Prepare the process documents and record forms required for injection molding \x0d\3. Check whether the manipulator and conveyor belt can work normally \x0d\4. The foreman arranged the operators to operate the machine. 5. Operators should prepare containers and packaging materials needed to hold products \x0d\6. Operators should clean the conveyor belt of the manipulator and their own workbench \x0d\ 2. Security requirements \x0d\ 1. Workers must wear labor protection articles according to regulations before taking up their posts. It is not allowed to wear untidy clothes and slippers into the production workshop. 4. New employees should go to the injection molding workshop to receive "Six Preventions" safety training within one week. He is in a bad mental state or is not allowed to work after drinking. Start step \x0d\ 1. The technician starts the injection molding machine, sets the temperature according to the process parameters, and heats the injection molding machine for 30 minutes \x0d\2. According to the requirements of production schedule. Keep the positioning position of the manipulator, and the mold opening position is 5- 10cm \x0d\4. Adjust the position of the manipulator clamp to make it correspond to the position of the product material rod \x0d\5. Check whether the parts of the injection molding machine and manipulator are loose before starting the production \x0d\ 4. Work steps \x0d\ 1. Prepare packaging bags or blister boxes according to different products. 2. Take the product out of the mold with a fully automatic manipulator and transfer it to the workbench \x0d\3. Disassemble and classify products according to product model \x0d\4. Check for defects such as no glue and wrinkles. On the product appearance \x0d\5. The good and bad products are classified and packaged, put in different areas and marked \x0d\ 5. Quality control \ 1. Operators are required to conduct self-inspection on product appearance every 10 \x0d\2. If serious problems such as material shortage, flash, burr, oil stain and hole sealing are found during self-inspection, they should be removed and thrown into the pulverizer \x0d\3. If the quality problem persists, it should be reported to the technical personnel on duty to solve it. Patrol inspection in each shift. If the performance is abnormal, it should immediately report to the technicians \x0d\5. For quality problems that cannot be solved by more than one shift, the quality supervisor should coordinate with multiple departments to discuss, analyze and solve \x0d\ 6. Emergency plan \x0d\ 1. If equipment problems are found, the shift supervisor or workshop supervisor should be on duty immediately \x0d\2. If unsafe factors are found, they should be reported to the mechanic on duty or workshop supervisor immediately. If nonconforming products are found in finished products, the inspector shall immediately mark them as "nonconforming" and the operator shall be responsible for rework \x0d\4. In case of power failure, fire, etc. The squad leader should organize employees to evacuate to a safe area outside the workshop \x0d\ 7. Maintenance requirements \x0d\ 1, plastic particles, cable ties, packaging materials, etc. It is not allowed to fall on it. 2. Unused tools and fixtures should be evacuated in time, and those needed should be put in a reasonable position. 3. Equipment and ground should be kept clean. 4. The Equipment Department shall carry out daily, weekly and monthly three-level maintenance on the injection molding machine, pulverizer and manipulator.