Current location - Education and Training Encyclopedia - Education and training - Minutes of fire safety meeting
Minutes of fire safety meeting
Minutes of fire safety meeting

Meeting minutes are narrative and introductory documents processed and sorted out on the basis of meeting minutes. The following is the minutes of the fire safety meeting that I carefully arranged. Welcome everyone to refer to it, I hope it will help you.

Recently, two fire accidents occurred in the urban area, which caused great harm to life and property. In order to strengthen the awareness of fire safety, a fire safety meeting was held on February 3, 20 12, in order to realize the fire control system of safety first and prevention first. General Manager Lin's safety measures and preventive requirements for the whole plant are as follows:

First, open fire prevention

1. Smoking is prohibited in the factory. If you smoke, you must stay away from the factory for 20 meters and put out cigarette butts or in designated areas.

2. Employees are forbidden to carry lighters and other inflammable and explosive articles with them during work.

Second, electricity safety.

1. It is strictly forbidden to set wires at will, and overload electricity.

2. There must be a special person in charge when using the electric furnace in the process of boiling glue, and it is forbidden to keep the person in charge away from the electric furnace when boiling glue.

3. Regularly check and maintain the power supply, sockets and lines, and replace the aging lines and components in time to prevent the' security risks' caused by aging lines.

4. Each department should turn off the power supply and check it in time after work, and can leave only after it is confirmed to be turned off.

5. If any potential safety hazard is found, it shall be reported to the leaders of all departments in time and handled in time.

Third, the factory fire environmental management

1. Abandoned scraps of paper are strictly prohibited to be discarded at will.

2. Waste paper piles should be checked every day to prevent harm, and the equipment should be isolated from inflammable and explosive articles.

3. The warehouse should be inspected regularly, and all kinds of paper products and cartons should be neatly stacked. It is forbidden to bring lighters into the warehouse.

Fourth, increase fire fighting equipment.

1. The full-time administrator is responsible for the daily use and management of fire control facilities, and the full-time administrator checks the use of fire control facilities every day to keep the facilities clean, hygienic and in good condition.

2. Maintain the technical performance of fire-fighting facilities and fire-fighting equipment and conduct regular technical inspection, arrange maintenance in time if any abnormal situation is found, and keep the equipment in good technical condition.

Five, fire safety education and training system

1. Organize employees to study fire laws and regulations on a regular basis, so as to achieve fire control according to law.

2. Each department should conduct fire safety education and training according to the post characteristics.

3. Conduct on-site demonstration and training for the maintenance and use personnel of fire control facilities.

4. Conduct pre-job fire protection training for new employees, and take up their posts only after passing the examination.

Meeting requirements:

1. In the design center, Lv Fujun and Jiang Lin investigate and deal with the existing fire hazards.

2. Xie Gang and Li Zongshun carried out a comprehensive fire hazard cleaning in the workshop and replaced unqualified sockets, switches and wires.

3. It is required that from now on, all equipment will be cut off after work, and the rented warehouse outside shall not use lighting facilities, and emergency lights or flashlights shall be used to distribute materials at night.

;