Current location - Education and Training Encyclopedia - Education and training - Armor wearing course
Armor wearing course
The course of wearing armor is as follows:

First, trim the dead skin on your hands. If it doesn't last long, polish the nails with a polishing stick first, and then gently roughen the nail surface so that the jelly glue can lie firmly on it.

Then wipe the nail surface with alcohol tablets, clean the nail surface, and stick a jelly sticker on the nail surface. You can't put it all on after wiping. Because it is easy to produce dust, jelly is not sticky and will bubble.

Continue to choose jelly glue suitable for nail size. The width of jelly paste should not be wider than the width of nails. Lift up the blank space and remember not to stick to your hands, or the jelly glue will become non-sticky. Then press from the middle to the side with your hands to discharge bubbles and let the jelly glue lie firmly on your nails.

Then tear off the film on the jelly glue, take out the appropriate nail plate, press the nail plate along the edge and push it to a distance of about 0.5MM from the trailing edge. Because the jelly glue is elastic, it will move back later to leave room to avoid pushing the meat.

Finally, repeatedly press hard from the middle to both sides until you are obedient, and discharge bubbles, so that you can paste the armor. Is it super simple? As long as the method is correct, it usually lasts for several weeks.

Step 1: Clean your hands and keep them clean before using armor. Step 2: Trim the nails with a nail clipper, and adjust the nail shape according to the armor A. If the armor is short, the nails should be shortened accordingly.

Step 3: Prepare nail pieces corresponding to the nail size, one for each finger. Step 4: Use a sponge file to polish the dead skin on the nail surface and around the nail to remove the dead skin on the nail.

Step 5: Clean with alcohol cotton to wipe off the grease and dust on the nail surface. Step 6: After the nail surface is completely dried, select pectin with the appropriate size of its nail surface and stick it on the side corresponding to A, and press 10 second hard to ensure that it sticks firmly.

Step 7: Select the corresponding nail plate, tear off the protective film on the other side of pectin, so that the nail plate and nail are attached at a 45-degree angle, and then press 10 second.