1, horizontal pen

The horizontal pen is low on the left and high on the right, and the pen should be strong and powerful, not too hard. Pull horizontally to the right and then press on the pen holder to take back the pen. Take back the pen gently and quickly.

2, hanging needle vertical

Pull it straight down, find the right length, press it slowly, and then slowly lift the pen off the paper to expose the front. The key point of the hanging needle is vertical, and the size of the head, middle and tail is proportional.

Step 3 tilt

A circular stroke, slightly inclined, forming a 45-degree angle with the parallel line, gradually revealing to the left and downward. Note that the exposed front is too sharp and floating.

4. Vertical skimming

The biggest difference between vertical skimming and oblique skimming is that vertical skimming is a continuous line brush with vertical skimming and short skimming. Draw the pen vertically, then bend it short to the left, with a thick front and a 60-degree tilt.

5. Short skimming

Short strokes are between oblique strokes and vertical strokes. Therefore, the inclination angle of short strokes should be less than 45 degrees, the strokes should be down to the left, and the length should not be long. The strokes gradually exceed the front, and the front is thick but not sharp.

6. oblique si

Oblique stroke is the reverse stroke of oblique stroke, with a straight nib and a slight arc potential to the lower right, with an inclination of 45 degrees. When the appropriate length is slightly shorter, draw the front face, and the thickness of the front face is not sharp.

7. The correct view

At the right point, write the pen with a sharp angle of 45 degrees, write the pen on the right side, and then return the pen to the front in the same way, with the pen accurate and light.

8. Oblique hook

Write at 45 degrees, write slightly in an arc to the lower right, and finally hook slightly. The hook should be slightly vertical, short and pointed.

9. Cross-fold

Start from left to right, and then pull horizontally to the turning point at an angle of 15 degrees. At the corner, stop the pen to the left, and then close it up.