A), the correct way to hold a gun:
Hold the front handle (type 97- 1) with the left hand, hold the tail of the case with the right hand, put the thumb on the left side of the case, put the index finger directly on the right side of the case, and hold the trigger holder with the other three fingers. The gun body forms an angle of about 45 degrees with the gun body, and the muzzle is inclined to the upper left. 2) Gun inspection: a) Turn off the trigger safety (there is no red sign at this time); B) Press the index finger of the right hand into a safe position, pull the front handle (or wooden hand guard) to the rearmost position with the left hand, open the shell throwing window, check whether there are bullets in the gun chamber and magazine through the shell throwing window, then put your finger into the gun chamber and magazine, and confirm again by touching; C) Push the handle (or guard) to the front position to form a complete lock; D) Open the trigger safety, pull the trigger and close the trigger safety. (3) Loading bullets: (2) When loading bullets, the gunman should point the gun in a safe direction, and it is forbidden to point the gun at people. First of all, the following actions should be completed: close the trigger safety, pull the front handle back to the rearmost position, and then send it to the frontmost position, so that the gun is in a locked state. Then load the bullets according to the following methods and essentials. 〉〉〉〉〉〉〉〉〉〉〉〉〉〉〉〉〉ԑԑԑ When the bottom of the bullet faces backward, hold up the ammunition feeder with the warhead and push the bullet into the magazine with your thumb instead of your little finger. Note: when the bullet is pushed into the magazine, it will make a "click" sound, indicating that the bullet is in place. Otherwise, if the hand is not in place, the bullet will easily jump out or fall on the ammunition feeder, which will affect the next loading. (2) emergency loading method (also known as single-shot loading, usually without this method). When the situation is urgent, there are no bullets in the gun bore and magazine, and it is necessary to choose the type of bullets to shoot, this method can be used for loading. Its action essentials are as follows: a, the gun holding action is the same as the "standard loading method"; B, the right index finger is pressed to a safe position, and the left hand pulls the front handle backwards to the rearmost position; C, the index finger of the right hand touches the bullet top mark to take out the required bullet type; D, the index finger, thumb and middle finger of the right hand cooperate to load the bullet into the shell throwing window with the bottom facing backwards; E. Push the handle forward with the left hand to the foremost position, and load the bullet. Open the trigger and fire. 4) Aiming shooting: The aiming system of 97 18.4mm riot gun adopts notch and shutter, and the aiming method is the same as that of military gun. After the bullets are loaded using the standard loading method, the bullets are located in the magazine. If you want to shoot, you need to press your right index finger in place, then pull the handle to the back position with your left hand, and then push the handle to the front position to form a lock. At this time, the bullet is loaded, and the trigger can be opened to shoot. Selection of scale: the scale used for killing bombs and kinetic energy bombs is1; Grade 2 is a painful mass bullet; Tear gas bomb adopts level 3. When using 97 riot gun to aim and shoot accurately, it is necessary to pay attention to the handle being more than 20cm away from the face to prevent the face from being injured by the recoil of the gun. (5) Retraction: a) Point the muzzle in a safe direction; B) close the trigger safety; C) Push the handle backwards to the middle position of the stroke, with the index finger of the right hand pushing the magazine upwards, with the index finger blocking the position of the magazine mouth, and then pull the handle backwards to the rearmost position with the left hand, during which one bullet exits the magazine and is caught by the right hand, and then press the leaf spring on the right side of the magazine with the index finger of the right hand to exit one bullet at a time, so that all the remaining bullets exit in turn; D) Check the gun again after the bullet is discharged to ensure that there are no bullets in the gun. 6) Ammunition replacement: 97 18.4mm riot gun is equipped with a variety of ammunition to adapt to different occasions. In battle, due to the change of target nature, ammunition needs to be replaced. How to change ammunition quickly is the key to mastering the initiative. Change bullets by using the principle that bullets are pressed in and fired first.
The operation method of changing bullets is as follows: 1. When changing bullets, there is a bullet in the chamber, and the front handle is at the forefront position. Take 1-2 bullets and load them into the magazine; 2. Press the right index finger in place for insurance; 3. Hold the front handle with your left hand, pull it back in place, and the original bullet in the chamber exits. 4. Push the front handle forward, and the required bullets have been loaded. Pull the trigger and you can shoot. Changing ammunition quickly is an emergency measure. If a variety of ammunition needs to be replaced, it should be quickly withdrawn and reloaded during the interval of fighting.