(1) Fire throwing method: roll the tissue paper into paper roll or cut into thin paper strips. When the temperature reaches 1/3, put it in a jar and quickly tap the cupping at the selected part. When throwing fire, whether using paper roll or paper, it must be more than one inch higher than the jar mouth. When it is burned to about one inch, the paper roll and paper can stand on one side of the can, and the flame will not burn the skin. For beginners, you can also stick a layer of wet paper or apply some water to absorb heat, which can protect your skin.
(2) Flash fire method: Use No.7 ~ No.8 thick iron wire, one end of which is wound with asbestos rope or wire tape, and make alcohol hold.
Before use, dip the alcohol stick in 95% alcohol, light it with an alcohol lamp or candle, and flash one end of the alcohol stick to the bottom of the can with flame, and then take it out quickly. Immediately pull cupping at the right place. At this time, the cans have become negative pressure and can be sucked.
The advantages of flash fire method are: when the alcohol stick is flashed, the flame has left the cupping, and there is no fire in the cupping, which can avoid scalding and is superior to the throwing fire method.
(3) Dripping method: Drop 1 ~ 2 drops of alcohol into the middle of the inner wall of the jar, rotate the jar for a circle to make the alcohol adhere to the inner wall of the jar evenly (don't touch the jar mouth), then ignite the alcohol with a match, put down the jar mouth and tap the jar mouth quickly at the selected position.
(4) Cotton sticking method: Take a small piece of absorbent cotton about 0.5 cm square, dip it in alcohol thinly, stick it to the middle section of the tank wall, light it with a match, and immediately buckle the tank at the selected position.
(5) Arson method: prepare a wood block with a diameter of 2-3cm, which is not easy to burn and transfer heat, put it on the part to be pulled out, put a small piece of alcohol cotton ball on it, light the cotton ball, fasten the jar immediately, and suck it immediately, which can produce strong suction.
* * * Air extraction method: firstly, fix the air extraction tank ground from waste bottles such as penicillin and streptomycin at the part where the cup is to be sucked, and use a syringe to extract air from the rubber stopper to generate negative pressure, which can be sucked. Or put an air pump on the piston of a plastic cup or can to suck air.
Because it is easy to learn, the domestic vacuum pumping tank
As far as I'm concerned, cupping is very effective. It can be pulled out in bathhouses, baths, Chinese medicine, beauty salons, etc. It will be addictive.
Give it to me, hehe ~ ~