As long as one of the optical cat, wireless router and network cable is not Gigabit, the broadband network speed of 200M will be automatically degraded to1100mm, so you need to ensure that your wireless router, network cable and optical cat all support 1000M.
As for the network cable, it is recommended to use six types of network cable or seven types of network cable, and it is best not to exceed five types of network cable.
Extended data
As the infrastructure of network construction, the role of wiring system is very important. According to statistics, 70% of network failures are caused by poor wiring system. Therefore, when choosing a real six-category wiring system, we must pay attention to the following eight elements:
1. A real six-category system should meet six performance requirements, from connectors and cables to links and channels, including modules, distribution frames, jumpers and cables.
2. When submitting the system test report, the worst-case model defined in ISO/IEC11and TIA/EIA-568 standards must be adopted, that is, a 3-point 90m link or a 4-point 100m channel.
3. The manufacturer shall provide comprehensive test data of six categories of products and systems within the bandwidth of 250MHz, and can stand the comparison of parameters and indicators required by six categories of ISO/IEC11801and TIA/EIA-568 standards. The test results of some characteristic frequency points cannot represent the performance in the whole test bandwidth. ?
Manufacturers should also provide some test results from third parties and official institutions at home and abroad. The products are mature and commercialized, and six systems have been applied in engineering. Manufacturers can provide a full line of six types of products for users to choose from, adapting to any installation methods and configuration requirements of users.
Users can also request to use the on-site tester to test the links or channels submitted by manufacturers according to international standards to see if they can meet the six indicators. Manufacturers should provide installation training specifically for six categories of projects to integrators, and relevant integrators can only participate in the installation and construction of six categories of projects after training (users can ask integrators to show such training certificates).