The method of assembling sailboats is explained in detail.

Sailing is the sport choice of more and more people, because it keeps people away from worldly troubles and is extremely comfortable. So how do you assemble and play sailboats? For all sailing beginners, we must first cultivate a high sensitivity to wind, current and their changes. The following is an introduction to the method of assembling sailboats that I have compiled for you, hoping to help you.

Assembly method of sailing boat

Before sailing, the parts of the sailboat must be installed. The installation of sailboat parts is relatively easy to learn, and the knot used in the assembly process of sailboat parts is the content we should focus on. The quality of knots is directly related to the safety of navigation, so knotting has become the first task for athletes before they formally learn to assemble sailboats. In the final step of knotting the sailboat, just tighten the knot.

Sailboat assembly can be divided into two forms: onshore assembly and underwater assembly. It should be noted that when assembling a sailboat, the bow is parked against the wind, so that the sail can swing freely with the wind and will not generate force on the sail, thus preventing the sailboat from being blown to one side in the water before the formal sailing, and also avoiding the damage caused by the sailboat being blown down on land. Clear the accumulated water in the cabin and close the waterproof plug.

1, how to assemble sailboats on land

(1) The hull should be put on the ship first, and the bow should be against the wind.

(2) Arrange masts and sails. The installation of sails depends on the requirements of different ship types.

(3) Install the mast. The installation of the mast may be affected by the sail, which requires quick action. If conditions permit, try to help each other and operate together.

(4) Install the main sail rope, front rope, stern triangle rope and stay cable device.

(5) Install the rudder. When installing the rudder, be sure to pass the rudder rod under the stern triangle rope or the bottom rope of the stern pulley, and then install the rudder into the stern rudder seat. After completion, lift the rudder blade to prevent the rudder blade from being damaged when the ship and car move. Remember, connect the rudder with the hull with a rope to prevent losing the rudder when capsizing. When dragging the boat into the water, loosen the rope to prevent the sail from being affected by the wind, so as to avoid the sailboat falling off the boat and causing an accident. You must wait until the water is deep enough to push the sailboat into the water and make it sail against the wind.

(6) Press the rudder blade into the water. You can also press half of it first, and then deep water pressure to the end. According to the water depth, tie the rudder rope to the rope clamp of the rudder stock. Semi-insert the stabilizer and then fully insert it into the deep water.

2. How to assemble a sailboat in water

The requirements for assembling a sailboat in water are: immediately put down the stabilizer to prevent the sailboat from moving sideways after launching, and install the rudder, rudder rod and auxiliary rudder rod at the same time to keep the bow against the wind.

3. How to assemble the mainsail

(1) Insert the ear of the back corner of the sail (the iron ring at the lower corner of the main sail) into the groove on the mast and fasten the cable at the back corner.

(2) Connect the front corner of the sail with the movable chain and fasten the front corner rope of the sail.

(3) Connect the front sail edge of the main sail with the chute of the mast and fasten the sling of the main sail. Be careful not to twist the mainsail at this time.

How do ordinary people play sailing

For ordinary people, sailing is an unreachable dream, but small sailing is also a good entry choice. Laser class sailboat, 470 class sailboat, OP class sailboat suitable for teenagers, etc. It can be classified as a small sailboat, with a length of about 2 meters to 5 meters and a capacity ranging from 1 to 4. The entry threshold of this small sailboat is extremely low. The cheapest 20 thousand yuan can be bought, and the price of the bigger one is also around tens of thousands of yuan. If several people buy it together, ordinary citizens should be able to bear the price. But relatively speaking, there are very few individuals buying small sailboats in China, for the simple reason that there is no berth and no place to put them at home.

At present, all kinds of small sailing clubs are in the ascendant in coastal cities all over the country, and small sailing boats can even sail in inland lakes, which is more popular. Small sailing training is about several thousand yuan, and the daily rent can be as low as one or two hundred yuan. Some small sailing clubs have even passed ASA certification, and they can get the certificate directly by passing the club exam.

Sailing is a sport at sea after all, and the unpredictable natural environment at sea adds some risks to sailing. Please pay attention to safety when sailing.

Maritime safety equipment.

Everyone on the boat is wearing a life jacket.

◆ There are extra anchor cables.

◆ Wide-bladed short paddle

◆ Drainage equipment

◆ Horn

◆ compass

Tools such as knives, pliers, screwdrivers and tape measures.

◆ First aid kit

◆ Adequate moisture.

Guess you like:

1. What should beginners pay attention to when snorkeling?