1. Click to enter the endnote setting page.

2. Set endnote, select the end of the section, and then click Apply.

3. Therefore, endnotes will be generated at the end of this section.

4. Click the chapter navigation to see how many chapters there are in the article.

5. Find the directory that knows the end of the chapter, move the cursor to the previous chapter, click the separator, and divide it into the next page. You can use the same method to refer the table of contents and the previous section of the table of contents to a paragraph and delete the extra spaces.

6. It is divided into four sections, the middle section and the reference section.

7. Find the part where the reference is located, and click Merge to the front part to make the operation a part until the middle part. References are followed by documents where separators can be inserted.

The steps of automatic generation of thesis catalogue are as follows: Tool: 202 1 version of WPSword document. Operating system: win0. Computer: Lenovo notebook Y50-70AM-ISE.

1. Open the WPSword document, delete the original directory, click the reference to select the insert directory, click the option, enter 1 after the title, and then click OK.

2. Click OK again, and the directory will be automatically generated;

3. After modifying and adding the title of the paper, click on the references to select the updated directory;

4. Click OK again, so that the directory can be generated directly, which is very convenient.

The automatic generation steps of the thesis catalogue are as follows: Computer: ASUS A456U. System: win7.

1. Open the word document on the desktop and enter the directory you want to change.

2. Select the text that needs to be set as the first-level title, and click "Title 1" under the "Start" option in the ribbon.

3. Hold down the ctrl key to select all the words that need to be set as subtitles.

4. Click on "Title II" above.

5. Hold down the ctrl key to select all the text that needs to be set as the third-level title.

6. Similarly, click "Title III" above. Now that all the formats have been set, let's start generating the catalog.

7. Click "Enter" at the beginning of the first-level title to leave a spare line above it, put the cursor in front of the spare line, and then click "Reference" on the ribbon.

8. Find the first table of contents under Reference, and click to find the automatic table of contents below.