Dude, isn't the amount of heat you need per square meter a little big? It's no problem to use 10 ton boiler. When heating is started, it needs to run at full load, and after the temperature of each part reaches the required temperature, it can be 60-70% load.

If there is no steam demand, a hot water boiler can be used, which has low cost and high relative thermal efficiency. If environmental protection requirements are strict, gas-fired boilers can be used, which have high thermal efficiency. The 10 ton gas boiler produced by our company adopts the most advanced flue gas condensation technology. According to the low calorific value, the thermal efficiency can reach 100%, and the gas demand after normal operation is about 450m? /hour or so is enough. The gas boiler produced by our company can realize automatic operation with high safety factor and reduce the number of operators. The coal-fired boiler adopts patented grate, which does not leak coal. If necessary, you can contact us further, and we can make professional calculations. Because it is seedling raising work, it is best to put two boilers at the same time, one for use and the other for standby.

All right, that's all. I hope it helps you. If you need anything, you can contact me further.