1, process flow of the pump.
The basic parameters such as pump flow and lift should be reasonably determined according to the process requirements. It is generally believed that the normal wear and tear of the pump and the change of rotating speed may lead to the decrease of head. Therefore, when selecting a pump, the lift of the pump can be 2%.
5% deposit, but not more than 10%. The basic principle is to ensure that the pump runs in a high efficiency range. In addition, by calculating the cavitation allowance of the device, the information of the inlet state of the corrosion-resistant pump can be obtained.
2. The corrosiveness of the medium and the choice of materials.
There are many kinds of chemical media with different properties, which require accurate characteristic parameters, especially corrosivity, concentration, volatility, vaporization pressure, viscosity and density. These properties are closely related to the choice of materials, not only metallic materials, but also nonmetallic materials and media.
3. Moderate temperature.
Temperature has a great influence on the structural selection of chemical pump, such as the support mode of corrosion-resistant pump body and the design of cooling (or insulation) system, which are closely related to the temperature of conveying medium.
4. Selection of spindle seal and its auxiliary system.
According to the actual case analysis, the proportion of fault units caused by spindle seal is very high, which can reach 30% ~ 40% in some occasions, so the selection of spindle seal is very important.