Education 2002-2006 Graduated from Qingdao University of Science and Technology, majoring in Polymer Materials and Engineering, 20 08-20 10 Attended the sixth and seventh national rubber formula design quality training courses of Beijing Rubber Design Institute and obtained the certificate of formula designer. From 2008 to 2065, he studied the EU REACH regulations at 38+00. EU tire labeling regulations successively studied rubber compound design and on-site process management with Mr. general SAM, a formula inspector in North America before Michelin, in 2009 10. In September, 20 10, he studied the "Michelin low temperature one-step rubber mixing" method in a technology export company. (One-step formation of adhesive joint and SAP master rubber system at low temperature)
Work experience: from 20051February to now, I have worked in a state-owned commercial tire company. At present, he is the technical director of the intensive construction center and the technical assistant of some workshops. Mainly responsible for on-site processing technology management, formula design and improvement, quality certification of ISO/ TS 16949 quality system establishment center, and other technical management work. At present, he is responsible for a series of preparations for the second phase of the company's construction center, such as intensive revision of ironmaking process and technical process training for employees. In March 2009, the smelting process of side wall mixed iron was optimized and the formula of side wall was improved, which reduced the waste products caused by sulfur particles in side wall. Due to the improvement of the quality of sulfur particles on the side wall, the qualified rate of three times increased by 0.025%. This project won the second prize of the company in 2009. In 2009, some workshops were entrusted1/month, and the total amount of special-shaped rubber compound in the processing unit workshop was 18.2 tons, saving the company 400,000 yuan. 2009-20 10 During the two years when the technical director was sent abroad, a large number of high-quality and low-cost tire formulations were developed successively. In particular, the single tire cost of the tubeless anti-seepage glue formula has dropped as much as 12 yuan. In view of the phenomenon that the vulcanization time of the company is too long at present, a sulfur process improvement and temperature measurement team has been set up, and a large number of vulcanization temperature measurement experiments have been carried out, and the vulcanization time has been shortened by 5-9 points. Not only reduced energy consumption, but also saved a lot of energy consumption funds for the company. The project won the first prize of energy saving and consumption reduction in 2009, and was well received by all employees of the group. At present, the project is still in progress.
My personal specialty has been in business for six years, and I have a deep understanding of the technology and formula of all-steel radial tire, and I have a deep foundation and experience in the technology and formula of all-steel radial tire. Familiar with the iron mixing characteristics of F series and GK mixers, and familiar with the iron mixing technology of different types of rotors. Have a deep understanding of the reinforcement of white carbon black and iron mixing. Have experience in deep processing technology management, and can process all kinds of special-shaped slurry independently. The existing iron mixing process can be optimized to the greatest extent. Have a deep technical foundation of basic skills, especially "one step at a time". At present, I have accumulated a lot of empirical data and have my own set of plans. Good communication skills and strong contacts in the tire industry. Most tire companies in China have classmates and alumni. Be able to master the first-hand information at the first time and keep abreast of the new trends of domestic tire technology.