1, check whether the electronic drain valve is damaged.

2. Open the upper cover plate (four self-tapping screws) between the inner and outer barrels of the washing machine, and carefully check whether the water outlet hole between the inner and outer barrels of the washing machine is blocked by foreign objects.

3. The SCR of the control panel that controls the drain valve is broken.

Related instructions

In order to make the washing machine run normally for a long time, it must be lubricated and maintained correctly on time. The main components that need lubrication are bearings and gears. Bearings need to be filled with L-TSA22 antirust and antioxidant lubricating oil with good wear resistance and oxidation stability through the oil injection hole, usually once every 2-3 years, or once a year if general mechanical oil is used.

The gear is lubricated with No.2 extreme pressure lithium-based grease with good adhesion, or zinc dialkyl dithiophosphate with a mass fraction of 1% or MoS2, L-CKC 100 gear oil with a mass fraction of 3%.

The bearings and gears of the dryer should be added with L-AN 15 and L-AN68 lubricating oil with good oxidation resistance, rust prevention and wear resistance every year or half a year. If sealed rolling bearings are used, polyurea-based thickened refined petroleum lubricating oil with service life longer than 1000 hours shall be sealed by the bearing factory, and No.2 lubricating grease with rust prevention and oxidation resistance shall be added.