Take out all the parts, put them in a spacious and flat place, and compare them with the schematic diagram of the cage you bought to see if there are any omissions and classifications.

2. Install the side panel.

Stabilize the chassis. When installing the side plate, it is easier to find and correspond the concave-convex groove between the side plate and the chassis, but you must not use brute force when installing. When I installed it myself, I broke a plastic piece because of uneven hand strength, which was very annoying and even affected the tightness of the cage "fence".

3. Install the grid.

The net should be installed by side plates. If the side plates are installed correctly, the net can be put in from top to bottom. However, the grid must be able to touch one side of the edge and put it outside. This should be consistent with the last top cover, which can be determined by looking at the groove of the top cover.

4. Install the food basin.

When you get the dish basin, you will find something similar to a small clip on its side, and then find a place on the chassis to put the small clip in, according to the seat of the groove.

5. Install the kettle.

First, take out the transparent tube like a straw from the kettle, and fill the kettle with water, which must be filled for the first time. Then cover the cork, insert the transparent tube into the hole of the cork, and test whether it leaks for the first time.

After the test, choose the height according to the position of the basin, and install the fixing buckle first, so as not to cause the kettle to be unable to be installed.

6. Install the drive wheel.

The running wheel needs to be installed by itself before being installed on the internet.

The most important thing is that the runner didn't take it for granted to buckle the opponent through the net, which is a big mistake. You must install the runner first. If you hold it in your hand, it is a runner. Install it on the internet.