1. First click Start on the computer, then select Execute, enter services.msc, right-click WiredAutoConfig, and select content.

2. Secondly, click the General tab and select the following settings: Set the startup type to automatic, click Start, wait for the service to start, click Apply, and then click OK.

3. Then, click Start again, select the console, double-click the network connection, right-click the local connection, and select content for further configuration.

4. Then, click the General tab and select the following settings: Double-click InternetProtocol(TCP/IP), select Automatically obtain IP address and automatically obtain DNS server address, and click OK.

5. Then click the authentication tab and select the following settings: check Enable IEEE802. 1X authentication, select ProtectedEAP(PEAP), and click Settings, as shown in the figure, to cancel all inspections.

6. Finally, when selecting the authentication method, select SecuredPassword(EAP-MSCHAPv2), click Settings, uncheck it, and then click OK. After the setting is completed, a message will pop up in the notification bar immediately. At this point, click Info, then enter UMPASS account name and password, and click OK to save the changes.