According to the construction plan of IPv6 resident network (Phase I) of Yunnan University, the areas where IPv6 trial network was recently opened include: Network and Information Center and Supercomputing Center of Yunnan University, Gewulou area of Yangpu Campus, some teaching laboratories of School of Information and School of Software, and all student apartments and dormitories in the headquarters. Other areas will be gradually opened up depending on the trial and the second phase of construction. Teachers and students in the open areas are welcome to actively participate in the IPv6 experiment.

Note: Accessing the Ipv6 network is simple and convenient. You only need to install and configure the IPv6 protocol and connect to the campus network. You do not need to configure an IPv6 address. When accessing IPv6 resources, the access to existing Ipv4 resources will not be affected. Teachers and students are welcome to put forward valuable suggestions in the process of use.

Attachment: Installation and configuration methods of IPv6 in each system.

Yunnan university network Yu information center

2008.9. 15

Attachment: Installation and Configuration Method of IPv6

1. How to install configuration in widower 2000, 2003, xp system?

Enter the command line mode (start, run, enter cmd, and confirm), and run ipv6 install to indicate that the installation is successful.

Ipv6 installation command description: Install IPv6 protocol stack.

Operation example:

Ipv6 uninstall command description: uninstall the IPv6 protocol stack.

Operation example:

2. IPv6 configuration of 2.WINDOWS VISTA system

Generally speaking, VISTA already supports dual stack of IPv4 and IPv6.

3. IPv6 configuration of 3.Linux system:

Linux supports IPv6 after kernel version 2.2.0. Please check whether the file /proc/net/if_inet6 exists to determine whether your system supports IPv6.

If not, try the following command to load the IPv6 module:

# modprobe ipv6

After successful loading, you can use the IPv6 environment.