Tools/raw materials
notebook
Phillips screwdriver
Random access memory
How to disassemble the notebook memory?
1, turn it off and unplug the power supply, mouse and its equipment! ! ! Generally, the memory of the notebook is in the back.
2. Find the location of the memory stick.
3. Use a Phillips screwdriver here to remove the memory cover. (Pay attention to the bayonet of the cover plate)
4. There are elastic cards on both sides of the memory.
5. Gently push out the two elastic cards in the memory with both hands! ! !
6. Slowly, the memory stick will bounce.
7, so you can unplug the memory stick.
8. You can look at the memory card slot here.
9. When the memory stick is taken out, you can use an eraser to wipe the metal sheet (golden finger) for oxidation and so on.
How to install and add memory chips in notebook memory?
1, I talked about how to disassemble the notebook memory, so the installation is relatively simple.
Here, pay attention to the angle and bayonet alignment when installing.
2, gently push in, push tight and then gently press the elastic card will automatically buckle! ! !
3. If you want to add a memory stick, first pay attention to the memory in the card slot below. Then plug in the memory module you want to add (wipe the metal sheet (golden finger) with an eraser before installation). Note: when adding memory chips, write the right memory type, preferably the same brand! ! !
(Different brands of memory are sometimes incompatible, such as DDR3 1600, DDR3 1333, DDR2 800, DDR2 667, etc. -DDR 2 is different from DDR3. )
4. Install the cover plate for locking the memory and try it on.
The above is the introduction of how to disassemble and assemble the notebook memory and how to add the memory bar. I hope it will help everyone!