Current location - Education and Training Encyclopedia - Educational institution - What are the physical fitness assessment items and standards of the police recruitment examination?
What are the physical fitness assessment items and standards of the police recruitment examination?
Hello, Chinese public education is at your service.

Detailed rules for the implementation of physical fitness assessment of the people's police employed by public security organs

I.10m× 4 round trip

Site equipment: There are several linear runways with the length of 1 0m, and a line is drawn 30cm away from both ends of the runways (S 1 and S2) (Figure1). Each lane has 3 pieces of wood (5cm× 10cm), of which 2 pieces are placed on the horizontal line outside S2 line, and 1 piece is placed on the horizontal line outside S 1 line. Several stopwatches should be calibrated before use.

Test method: After hearing the call, the testee starts to stand, starting from the outside of S 1 line. When he ran to the S2 line, he picked up a building block with one hand and ran back. When he ran to the front of S 1 line, he exchanged squares, then ran back to S2 to exchange another square, and finally rushed out of S 1 line with the square, and recorded the whole time. Records are recorded in seconds, with one decimal place reserved. When the second decimal place is not "0", it is 1.

Note: When the subject picks up and puts on the block, his feet cannot cross the lines S 1 and S2.

2. Men's 1000 meter run and women's 800 meter run.

Venue equipment: 400m track and field track. The ground is flat and the geology is unlimited. Several stopwatches should be calibrated before use.

Test method: Subjects are divided into groups with no less than 2 people in each group, starting with a standing start. Start running when you hear the password or whistle. When the subjects reach the finish line, the watch stops, and the finish recorder is responsible for recording everyone's scores, which are recorded in minutes and seconds, regardless of decimals.

Third, jump and touch the height

Site requirements: The test is usually conducted in an indoor site. If outdoor field test is selected, it should be carried out when weather conditions permit. The average temperature of the day should be between15 and 35 degrees Celsius, with no direct sunlight and no wind exceeding level 3.

Test method: When preparing for the test, the subjects' feet naturally stand apart. After receiving the instruction, the subjects bend their legs for half a squat, swing their arms backwards as far as possible, and then swing their arms forward and upward quickly, with both legs exerting force at the same time, trying to take off vertically and upward, and at the same time raising their hands to touch the test paper of the fixed height line or automatic height touch device, and those who touch the height line or test paper are considered qualified. Test no more than three times.

Note: (1) When taking off, the subject's legs can't move or there are steps; (2) The fingernails of the subjects shall not exceed 0.3cm of the fingertips; (3) Subjects are not allowed to carry gloves and other items when touching with their bare hands; (4) Subjects take off their socks (socks can be worn) barefoot, and a hard inelastic pad of no more than 2 cm is laid at the place where they take off.

If in doubt, please consult the public education enterprises in China.