First of all, I declare that I am a novice, and experts despise such pediatrics. I want a novice like me to change the antifreeze himself. Get to the point, first open the water tank cover, turn it 90 degrees counterclockwise, then press the cover down and continue to screw it. There is also a cover on the auxiliary water tank next to it, which needs a little force.

The lid has been opened.

The lid of the kettle has been opened.

Then find the drainage screw, facing the car, on the right side of the car, and put a cardboard on the ground to see it.

The red cross on the left of the picture is.

Listen to the forum predecessors, it is best to use iron sheet. I'm from a machinery factory. Just pick one.

Originally, the two ends were the same, too wide.

These tools are easy to use.

On the artifact,

Unscrew the faucet, also counterclockwise, and put a basin under it.

ponding

ponding

Put antifreeze

Continue to play

continue

I ran less than ten kilometers before putting the antifreeze, and the antifreeze was still a little hot.

It doesn't look like it was stolen.

Think about blowing with compressed air,

off the rack