1 assemble spray gun

2 After trimming the dead skin, carve and polish the nails and clean up the dust on the nail surface.

3. Install the nail receiving bracket (the nail receiving bracket should be parallel to the nail, and don't tilt left and right, turn down or up.

4. Fix all extension brackets.

5 Apply primer and illuminate for 30 seconds.

6. Dip an appropriate amount of nail glue with a glue pen, evenly smear the joint between nail bracket and nail, and then make the desired length and radian (if it is not well controlled, you can use two fingers to operate it once).

7. Spray ink with a spray gun to smudge the lines, and turn on the light for 30 seconds.

8 Apply strong nail glue to prevent uneven nail surface, and then turn on the light for 60 seconds.

After 60 seconds, wipe off the floating glue with nail polish remover. "