1. Check whether the gear position has been reset and the ignition has started.
2. Put down the handbrake. If the ground is uneven, step on the foot brake first and then step on it. )
3. If you continue to move forward, please step on the clutch (the leftmost pedal is the clutch, the middle is the brake, and the rightmost is the accelerator). Pulling back the second gear means that the vehicle is driving in reverse, the lower left joystick is pulled back, and the right joystick is used to select the appropriate gear.
4. Move the fork up and down to the upper left joystick, move it up and push it. The front end of the fork will move up and down and press the upper right joystick, and the front end of the fork will drop and the joystick will rise.
Extended data:
Loading and unloading
(1) When loading goods with forks, the distance between the two forks should be adjusted as needed to balance the load between the two forks, and tilting is not allowed. One side of the goods should lean against the blocking frame, and the weight of the fork should meet the requirements of the curve mark of the load center.
(2) The loading height shall not block the driver's sight.
(3) In the process of loading and unloading goods, the forklift must brake.
(4) When the fork approaches or exits the goods, the speed should be slow and steady, and the wheels should not crush the goods, wooden mats, etc. , so as to avoid the crushed objects flying up and hurting people.
(5) When using a fork to pick up goods, the fork should be as deep as possible under load, and pay attention to the fact that the tip of the fork cannot touch other goods or objects. The minimum inclination of the mast should be used to stabilize the load to prevent the load from sliding backwards. When reducing the load, the gantry can be slightly tilted forward to facilitate loading the load and forks.
(6) Fork goods at high speed and hit hard objects with fork heads are prohibited.
(7) Forklift operation, it is forbidden to stand on the fork.
(8) Forklift fork operation, it is forbidden to stand around the fork, in order to avoid the collapse of goods.
(9) Forklift personnel are prohibited from engaging in aerial work to avoid falling accidents.
(10) It is not allowed to use braking inertia to slide objects.