02: Before starting the machine, check whether the berth is normal, the water level of the cooling water tank, the gap between the grinding wheel and the guide wheel and the supporting blade is normal, and whether there are working objects or sundries in the machine tool.
03: Before starting the machine, check whether the switch is reliable and confirm whether the safety protection of the protective cover is effective.
04: Turn on the power supply, start the hydraulic switch, observe whether the hydraulic gauge pressure of the machine tool is normal, and then check whether there is oil flowing through each mooring mirror and each mooring pipe.
05: Before starting, the whole grinding wheel and guide wheel must be wiped clean, and the parking cup should be filled with oil.
06: Before starting the machine, the operators must be trained according to the operating procedures, so that they can understand the operation process of each work.
07: Only after the above confirmation is correct can the machine be turned on.
08: Turn on the main power and start the machine. 09: Turn the hydraulic switch to the ON position.
10: check the parking mirror of the hydraulic system, and start the grinding wheel and guide wheel after the oil gauge is stable.
1 1: After the grinding wheel and guide wheel operate normally, turn on the water pump and adjust the appropriate water quantity.
12: Adjust the grinding 1-3 workpiece, first check the size and appearance of the workpiece, and put the adjusted product into the adjustment box.
13: mass production can only be carried out after the test is qualified.
14: After starting production, the operator must conduct self-inspection on the first sample according to the work instruction and record it.
15: If there is any abnormality in the production process, stop the machine immediately and fill in the relevant forms.
16: switch the water pump motor to the OFF position when shutting down, stop water supply, and take out the workpiece stuck in the machine tool.
17: The grinding wheel and the guide wheel idle continuously for more than 5 minutes, and the water supply is stopped to avoid the grinding wheel from being unbalanced when starting again. After draining water, turn the power supply of grinding wheel and guide wheel to the off position.
18: Turn the oil pressure switch to the OFF position only after the grinding wheel and guide wheel stop (don't stop the oil pressure motor first to avoid oil leakage and wear the bearing bush and spindle).