How to draw hand-drawn c2 in engineering system

1. Draw two intersecting straight lines on the drawing, representing the edges and corners of the parts respectively.

2. Draw an isosceles right triangle at the intersection of these two lines. The base of this triangle intersects with two straight lines, and its height is equal to the edges and corners.

3. Mark C2 above the triangle, indicating that it is a 45-degree chamfer, with 2mm cut off at both sides. This completes the hand-drawn representation of C2 chamfer.

Combination of cost document and modeling

Brief introduction of the author of "Splendid Cloud Building"

Examples of papers on dietary nutrition and health

When writing a paper in word, how to make each chapter start from the first line of the page?

Experience the standard of being a man and doing things from the Analects of Confucius. . About 2000 words, so all scores are rewarded! ! !

Where do the authors of English Literature Newsletters usually write?

Can there be no page number after national standard citation?

Introduction to the specialty of economic animal breeding with characteristics of in-service graduate students in Jiangxi Agricultural University

Praise the officials who wrote the composition.

Write a paper. Which do you think is the least safe in China? What is the reason? About 800 words, written for adoption.