Construction technology of wall covering. 1. Stone wall installation and construction technology The stone surface wall technology adopts slurry wet slurry: copper cable connection and slurry separation. The first pass shall not exceed 1/3 of the slab height, and the second pass shall be conducted after the initial setting of mortar. This time, the height is half that of slate, and the third layer is injected 5 cm below slate. For dark stone, 32.5Mpa ordinary portland cement medium sand or crushed stone, the mud content of artificial stone wall construction technology is not more than 3%, and the ratio is 1:3. The light-colored stone series is made of 32.5Mpa cement mortar, white cement and white stone chips. 3 ratio.
2. Dry construction technology: Installation of stone wall of building: All steel specifications must meet national standards, after rust-proof hot-dip galvanizing treatment, welded parts. The number of stainless steel for steel stone pendants should be higher than 202, or according to the actual needs of the project, the stone thickness of joint steel grade 304 must be greater than 20mm, the wall height is 2500 mm, and 5# steel groove must be adopted vertically, and the horizontal direction is 40 mm. x？ 40? Mm angle steel. The construction technology of artificial stone wall is determined according to the arrangement of stone transverse joints. Walls higher than 2500mm must be 8 in the vertical direction. # steel, the angle and spacing of 50mmx50mm steel in the horizontal direction are determined according to the composition of Hengfengshi.
3. Sticking glue in the construction process of building stone gypsum: the stone process sticks to the wood base, which is suitable for small areas and small pieces of building surface materials (such as cultural stones, decorative lines, motherboards). AB glue should be fixed with stainless steel screws for self-tapping and fixation, while the back of the rock is in the form of inverted 8-point holes, which must be dug for rust prevention.
Construction technology of wall covering. 1. Pay attention to the 45-degree splicing and diagonal processing at the corner of the wall stone. Construction technology of artificial stone wall After all paving stones are completed, marble glue with the same color as the stone used for sealing joints should be prepared. The seams must be tight.
Note that before laying all kinds of stones, the structural details designed or drawn according to the layout of the drawing are the field measurement of drainage lines, and horizontal elevation and grid lines appear on the center line and line wall.
3. First of all, pay attention to the installation of plates according to the design requirements. Construction technology of artificial stone wall drilling diameter 5? Hmm. The copper is in the hole. It is necessary to check the flatness of the enamel layer before installing the plate. If the fluctuation is too large, it must be leveled or leveled in advance.
4. Pay attention to the smoothness of cement mortar and residual mortar, dust, paint, etc. The base surface should be removed. In order to reach the leveling layer and make the base layer and leveling layer firm, polymer mortar can be sprayed before leveling layer.
After reading the brief introduction of artificial stone wall construction technology, you must understand that the construction of wall plastering stone is a complex decoration project. In the decoration, you should be familiar with the process and have an extra understanding of the relevant preventive measures. Here, Bian Xiao also hopes that the information about wall stone construction technology and matters needing attention will be useful to everyone.
Tubatu Online provides you with "every decoration quotation, 1-4 local decoration companies, 3 sets of decoration design schemes" and the decoration pit avoidance strategy for free! Click this link:/Zhu Ye /zxbj-cszy.php? to8to _ from = SEO _ zhidao _ m _ jiare & amp； Wb, you can get it for free ~