A must-see for students in subject three.

1. Adjust the seat

G First of all, make sure that your seat is adjusted to the right position, that is, when you lean forward to the steering wheel slightly, you can see the left rib line of the car, and the body is positive!

operate

1 When you hear the pull-over command, immediately apply the clutch brake to about 25km/h and turn on the right turn signal.

2. Release the brake and turn the steering wheel 90 degrees to the right quickly (3. When the left rib line just passes the left dotted line, the steering wheel immediately turns to the left 180 degrees! Note: this 180 degree must touch the left rib line and run to the left of the left dotted line before it can be straightened. The purpose is to pull your car over, and the right wheel of the car will not compact the line during calibration.

adjust the distance

Let the left rib line fall to the right of the left dotted line, and step on the brake when the tip of your nose or the highest point of the steering wheel is aimed at the blue dotted line on the road (another way is to aim the wiper at the solid line on the ground).

Park the car, pull the handbrake, put it in neutral, release the foot, turn off the engine, make sure it is safe, slowly open the door, and close the door after getting off.

Note: Be sure to pull the hand brake first! Because if the left wheel accidentally presses the dotted line and you don't know it, 100 will be deducted if it exceeds10 second, but the system counts seconds by hand brake. If you press the dotted line but pull the handbrake within ten seconds and stop counting for two seconds, you will only be right. When the distance between the side wheels is greater than 30cm, 10 will be deducted, and 90 points will still be qualified.