The programming process of machining center is very simple, and most of them are programmed by hand. If you program with a computer, it will be complicated. Generally, there are many mold processing programs without computer programming, so they can only be programmed by computer.
Anyone who has made products knows that products require very high technology, not only to be made, but also to be efficient and dimensionally stable. It is almost a race against time to consider the processing mode, clamping mode and fixture design, because the improvement of efficiency is the sublimation of profits, and the requirements for programmers' experience and tool use are very strict.
Attach importance to product processing programming
The control of speed feed, machining time and clamping time should be understood, and the parameters in the book cannot be copied because of different machining environments. Making molds depends on your proficiency in software, and making products depends more on the rationality of your process arrangement.
It is very difficult to process products, such as learning materials, learning tooling, comprehensive knowledge of cutting tools, fast feed and more valuable processing experience. In the past, ball end mill was used instead of a flat knife to make molds, and the machine was always operated to multiply for speed feed. As long as the shape is ok, leave a few lines at the matching place. The salary is hard to say. It's up to you.