1. Wet your hair with a watering can, and then separate the hair pieces evenly with a special hairpin. 2. Apply a perm water evenly on each piece of hair. 3. Turn every hair in the same direction, and it becomes a good hair shaft. 4. Wrap the hair piece with perming paper and plastic film. 5. Fix each hair shaft and hair piece with clips. 6. Connect the steam pipes to each fixed hair piece and connect all the steam pipes in series in the correct way. 7. Check the snorkel, open the steam meter and heat it with steam flowing in the tube for 3 minutes. 8. Turn off the steam meter and let the hair piece cool for about 3 minutes. 9. Remove the plastic film from the wig. 10. Let the hair piece cool for another one to three minutes, and wash off the medicine. 1 1. Set your hair after setting. Several points for attention in steam ironing: ● In order to save time, you can preheat the steam meter in advance until the water in it boils and steam comes out. ● The thickness of each hair piece must be uniform, and the hair shaft is fine, so that the amount of hair in the hair piece is less. ● When applying liquid medicine, you can smooth the excess liquid medicine on your hair with your fingers, saving costs. ● When you curl your hair, you must tighten it and wrap it around the hair shaft, so that each hair is evenly heated and the hairstyle will last. ● After connecting all hollow hair clips, be sure to check whether they are unblocked and leaking. ● The cooling time of hair is determined by room temperature. The higher the room temperature, the longer the cooling time, on the premise of not perm your hair. ● Don't wash your hair within 72 hours, so that the residual liquid medicine on your hair can last longer. ● Be sure to use its special potion. ●3 minutes refers to the time that the hair needs to be heated, excluding the time spent in the preparation process and styling process.