I. Installation Method of Wooden Door of Tata
1. Lay the gasket first, and then put the used tools on the gasket in turn. After unpacking the product, take out the product and put it on the gasket in turn. Check whether the product is damaged and make records. Then start the installation.
2. Secondly, assemble the door frame with self-tapping screws.
3. Place the door frame at the corresponding door. After that, fix the door frame in the doorway with a wooden wedge and a wooden brace. Pay attention to the difficulties when using wooden wedges and wooden supports.
4. Shake the styrofoam evenly for about 30 times before use. Inject styrofoam into the gap between the door frame and the doorway, with three points left and right and two or three points above. Pay attention to the uniform glue, and the glue injection area is about: the thickness of the door frame *( 150mm-200mm).
5. After the gun glue is completely cured, remove the wooden wedge and wooden brace. Install the door lock and hinge on the door leaf. The lock plate can then be installed on the door frame. Install the door leaf on the door frame. Debug the opening of the door leaf and check whether it is flexible.
6. When installing the door wire, be sure to add an appropriate amount of white glue into the slot of the door frame. Before installing the doorway line, the side opening lines on both sides must be installed first, and then the upper opening line must be installed. If the tenon groove is too tight during installation, the tenon of the doorway line should be planed by hand. Remember not to hit hard, especially the top line.
7. After the installation, the whole door should be inspected and debugged again, and the installation quality of the product must be guaranteed.
8. Finally, when using silica gel matched with the wall to close the junction between the doorway line and the wall and the ground, users can also use mortar to close the mouth as appropriate. The bathroom must use silicone to close the joint between the doorway line and the wall and ground.
2. What are the wooden door brands?
1. In the current door industry market, Maxim's market share is very large, its products are used in many places, and the favorable rate is also very high, which plays a decisive role in the door industry in China.
2. The brand quality of wooden doors developed and produced by Shangpin is quite good. Most of the wooden doors produced by its brand are mainly green. At present, it ranks in the forefront of the wooden door industry and is a trustworthy brand.
Guanniu is promoting the best quality products to consumers through independent innovation, and its strength is also very strong, and its competitiveness in the market is stronger than other brands.
4. Roland brand products are various, and Roland brand products can meet more demands of consumers. The market is also more competitive than other brands, and it is a product that consumers trust very much.
5. Speaking of wooden door enterprises in Northeast China, we usually talk about 3D wooden doors. Its influence is not generally large, and its status is even more prominent. If it is a leading enterprise in the wooden door industry, it is well deserved.
The above content is about the installation method and brand of Tata wooden doors edited by Bian Xiao. I hope that after reading this article, more consumers can understand the brand of wooden door.