Preparation tools/materials: bracelet thread, beads.

Specific operations/steps are as follows:

1 First, take a long enough hand loop, which is three meters long here. Fold this line in half and hold the crease with your left hand.

2. Wrap one of the two threads held by the left hand around the index finger of the left hand.

3. Then take off the small circle and hold it with your fingers.

4. Wrap another thread around the index finger of the left hand.

5. After winding from below, pass through the first winding small circle and tighten the first winding wire.

6. Continue to do it backwards according to the above method, paying attention to the tightness, which will be smoother.

7. As shown in the figure below, the bracelet can be knitted to a certain length, and then it can be put around the neck to determine the required length.

8. Take a beautiful bead and put the hand rope through it.

9. Then tie your tail in a knot.

Second,

Tools/materials: red rope, elastic thread, scissors, beads.

1. Take a slightly longer elastic thread and fold it twice to form four strands. Fold the fishing line through the elastic line in half.

2. Prepare beads and start beading into a red line.

3. Put on all the beads.

4. Take out one end of four wires and thread two of them through the coil at the other end.

5. Tighten the thread, tighten all the beads and tie the knot, preferably twice.