Step 1: The first draft usually has a high repetition rate (unless you are a great god who writes word for word). You can use Wanfang and papertest to test it and then modify it sentence by sentence. This system is sentence-by-sentence detection, which means that any sentence you copy will be detected. This detection algorithm is strict, and the analysis from the point of view of program is simple. So everything sold online is very cheap. After measuring 30 thousand words, it feels good and cheap. (Note: 1 does not include your senior thesis of the last graduate student, so be sure to pay attention to the revision. Personally, if the school uses Wanfang to do the test, there is no need to take the VIP test and so on.
Make a copy of the electronic version of the paper first, and keep one copy. According to the test results, in a backup test paper, the duplicate parts can be deleted first, and those that cannot be deleted can be modified within 15 words. It is best to add and subtract characters, and changing the order is of little use. Some references have been deleted. If they cannot be deleted, you can modify them first. English documents can be changed from 15 characters to one word. Hand in the revised ones and check the system again. The saved original paper is slightly modified and submitted to the paper version. That system is very troublesome. You can add many documents that you haven't seen or applied for. It can be seen that China people copy from each other, but in order to ensure the integrity and accuracy of the paper, don't change it at will. The paper version submitted must be considered, and it will not pass the test system after general inspection, so don't worry about the paper version.
Step 2: After modification, the repetition rate is greatly reduced. At this time, you can use HowNet to check. HowNet duplicate checking system is a piece-by-piece detection, which is more intelligent. After testing, it is basically to make some local changes. Finally, I checked with HowNet, and it was 4% online, but it was simply changed, and it was 1.5% at school.
Note: remember, the most taboo is to change the sentences of the paper illogical and illogical in order to check the duplicate, so that you can't escape the teacher. Haha, come on!
HowNet related spot check regulations:
If there are regulations, you can modify them first. You can reply after the modification. If the second revision fails, it will be over, and the paper or design will be handed in within the next 4 months. This is based on 30% plagiarism. If you plagiarize more than 50%, you will have to hand in your paper or design within the next 4 months. 1. Undergraduate graduation design (thesis) identified as plagiarism, including the total number of words repeated with other people's existing papers and works, is between 30% and 50% (including 50%), which needs to be revised by myself. After revision, you can take part in the college defense only after passing the test again. Those who are still unqualified after the second interview are deemed to have graduated. You must submit the rewritten graduation design (thesis) after 3 months, and then take part in the defense after passing it. 2. Undergraduate graduation design (thesis) identified as plagiarism, if the total number of words repeated with other people's existing papers and works exceeds 50%, will be directly treated as graduation. You must submit the rewritten graduation design (thesis) after 4 months, and then take part in the defense after passing it.
Detailed description of hownet system calculation standard:
1. After reading the introduction of this system, I have a question. This system is good for text copy recognition, but what about other contents, such as data and charts? Isn't it useless to detect it?
Among all kinds of academic misconduct, plagiarism is the most common and serious. At present, the detection system has reached a high level. The detection of plagiarism and tampering of charts, formulas and data is currently under development and has made great progress. You are welcome to continue to pay attention to the progress of this detection system and put forward more critical and constructive opinions and suggestions.
2. According to this system, less than 39% is displayed in yellow, so does it mean that it is within the tolerable limit? Recently, I read the news that the national social science fund project of a teacher in Shanghai University was cancelled because two papers he published were plagiarized, accounting for 25% and 30% respectively. Please specify what the warning line is.
Percentage only describes the proportion of overlapping words in the detected documents, and does not refer to the plagiarism of the documents. It can only be said that the greater the percentage, the more overlapping words, and the greater the possibility of plagiarism. Whether it is plagiarism or not and the severity of plagiarism need to be decided by experts after review.
3. How to prevent the academic misconduct detection system of dissertations from becoming a platform for personal revenge?
This is something we are seriously considering. At present, this detection system is only used by users at the institutional level. We have formulated a set of strict ... >>
How to reduce the repetition rate of papers? How to reduce the repetition rate of papers
First of all, when you finish the first draft of your paper, you should first check the software (all of which are sold online) to see which ones are written by yourself, which ones have low repetition rate and which ones have high repetition rate.
As for what you wrote, you don't need to modify it. Mainly to modify papers with high repetition rate. Some places with high repetition rate refer to whole paragraphs and partial sentences. To modify these sentences, you need to be patient enough and start modifying them sentence by sentence.
The methods to modify these statements mainly start from several aspects:
(1) Keywords
There will be some words in the paper that are the same as the references, and if they are not revised, the repetition rate will increase. For example, some proper nouns, in this case, you can choose to write these proper nouns in English and Chinese. In addition, explain proper nouns again.
(2) Word order
There are many ways to say a word. When you encounter a sentence with high repetition rate, you can choose to reverse the word order and refer to the change of "four". Affirmative sentences become paradoxical, active sentences become passive sentences, complex sentences become simple sentences, and simple sentences become complex sentences.
(3) Enriching sentences
This is mainly for short sentences. Short sentences are relatively difficult to change. We should try our best to enrich sentences and change short sentences into long sentences in our own language, which not only increases the number of words, but also reduces the repetition rate.
six
Patience is the key to revising papers. After all, when the paper is finalized, the repetition rate should be tested in the school test system. If it fails, it will be in big trouble. So patiently and carefully revise every point of the paper and turn other people's words into your own.
Yes, regardless of the detection method, the default citation method is in the form of endnotes, which is easy to identify. As for the endnotes, I put them like this: 1. Insertion method of document endnotes: 1. Add a tag: click the shortcut key ctrl+F:
Enter "e" in the search field and replace it with: "[&; ]"。
2. If something like 12345 needs to be expressed as 1-5, you can select it and then use the keyboard shortcut: ctrl+shift+H to hide the selected content, manually enter 1-5 yourself, and then click CTRL+SHIFT+'+' to put it in the upper right corner ~~OK ~ ~
var script = document . createelement(' script '); script . src = ' static . pay . Baidu/resource/baichuan/ns . js '; Document.body.appendChild (script);
void function(e,t){ for(var n = t . getelementsbytagname(" img "),a=+new Date,i=[],o = function(){ this . removeeventlistener & amp; & ampthis.removeEventListener("load ",o,! 1),i.push({img:this,time:+new Date})},s = 0; S<n. Length; s++)! function(){ var e = n[s]; e.addEventListener? ! eplete & amp& ampe.addEventListener("load ",o,! 1):e . attach event & amp; & ampe . attach event(" onreadystatechange ",function(){ " plete " = = e . ready state & amp; & ampo.ca......& gt& gt
How to reduce the repetition rate of papers
How to reduce the repetition rate of graduation thesis
The first trick of "anti-plagiarism": rewriting
The way to avoid "lying on paper" sounds stupid, but it is "practical", that is, rewriting. "It's not that the paper can't be copied, it's to see if you can copy it!" .
In fact, patchwork is not out of date. The key is to be careful not to reveal the clues. First find what you need in different materials, then change each sentence into a sentence pattern, put it another way, add some explanatory extensions, and make some additions and deletions. Finally, I organized these parts together, and the paper was completed. Although it's a bit cumbersome, the final paper is absolutely as brand-new as going to South Korea for plastic surgery! Seeing my paper on the polygraph is probably only a lament.