First of all, the test paper needs to be divided into two aspects after the test. One is to select the paper duplicate checking system for testing in advance, and it needs to be revised in time when the duplicate checking rate is high. The main purpose is to know the repetition rate of your own papers and then submit them to the school. Because the school has strict requirements, it should be revised until it meets the requirements of the school. Therefore, after the repeated inspection report is obtained, it will be modified according to the repeated contents marked in the report. If the duplicate checking rate is high for the first time, it is best to check the duplicate again after the modification is completed, so the duplicate checking rate basically meets the requirements.

Secondly, after the paper we submitted was tested in the school, the first repetition rate of the school was up to standard, so we can successfully enter the manual review, and only after the manual review is passed can we really pass. It should be noted here that when the repetition rate of the school is not up to standard after the first test, the paper cannot be simply revised. If it is serious, you may have to rewrite it or fail it directly. Normal graduation will also have an impact, so you must pay special attention.

Finally, as can be seen from the above, the difference between the two is quite big, so before the school has officially checked the papers, it must be checked in advance, so that it can be revised in time and the passing rate of the school can be improved. When choosing a duplicate checking system, you should also pay attention to it. It is best to choose a duplicate checking system that is consistent with the school, so that the duplicate checking results can be consistent with the school. At present, most schools use HowNet to check the duplicate, which should be based on the requirements of the school.