2

/9

Sampling: 1 Take a urine sample and put it in an airtight container.

Generally, it is the first urine sample in the morning, which has high diagnostic significance.

Take a urine sample, preferably a terminal urine sample.

three

/9

Take out the test paper, completely soak it in urine, and take it out after about 2 seconds. When taking out, gently discharge the excess urine sample along the mouth of the container. (Close the lid of the test paper barrel immediately after taking out the test paper. No matter whether it is used or not, it is forbidden to put the test paper back into the test paper barrel. )

four

/9

Gently pat the edge (side) of the soaked test paper on the absorbent paper to remove the excess urine sample. (Remember to put the test paper measuring block directly on the absorbent paper for water absorption treatment)

five

/9

Put the test paper (surface) into the stage, and the front end of the test paper slightly touches the bottom of the test paper slot of the stage.

six

/9

Press the "Test" key on the dashboard to enter the test state (don't push or pull the stage when the green light flashes).

seven

/9

After a test of about 1 minute, the stage will completely quit after the test. Then the printer automatically prints the test results.

eight

/9

Take out the test paper (for processing)

nine

/9

Take off the printing paper and see the test results.