1981September-1985 July, majoring in engineering automation at China Youshi University (East China), with a bachelor's degree;

65438+August 0985-65438+August 0986, studying in the Overseas Training Department of the State Education Commission of Sichuan International Studies University;

65438+September 0986-65438+July 0993, studied at McGill University, Canada, and obtained master's and doctor's degrees in chemical engineering;

65438+1September, 1993-65438+1September, 19951October, as a senior research engineer in Moldflow International Ltd, Australia, responsible for the "intelligent control of injection molding process" project;

1In February, 1995, at the kind invitation of the Hong Kong University of Science and Technology, he resigned as a senior research engineer at Moldflow and joined the University of Science and Technology as an assistant professor in the Department of Chemical Engineering, and obtained tenure; He was promoted to associate professor in 2002 and professor in 2006.

At the end of 2006, with the donation of Mr. Fok Yingdong, the fifth institute of HKUST-Fok Yingdong Research Institute was formally established. In order to apply its own R&D achievements to the development and construction of national science and technology, the Institute of Higher Education established the only "Polymer Molding Process and System Center" in the world in 2007, and served as the director of the center.

20 1 1 in April, he officially took over as the vice president of Fok Ying Tung Research Institute and concurrently served as the director of the Institute of Advanced Manufacturing and Automation;

On July 20 13, he was promoted to Chair Professor of Hong Kong University of Science and Technology;

20 15 1 month, was specially appointed as a professor by Zhejiang university.