1. Move the cursor to the position where you want to insert the reference, and then select Insert, Reference-Footnote and Endnote from the menu. 2. Select "endnote" in the dialog box, select "automatic numbering" as the numbering method, and suggest "section ending" as the location. 3. If AutoNumber is not Arabic numerals, select Options in the lower right corner and select Arabic numerals in the numbering format. 4. After confirmation, insert a superscript "1" here, and the cursor will automatically jump to the end of the article, which is preceded by a superscript "1", which is where the first reference is entered. 5. Change the format of the superscript "1" at the end of the article to normal, that is, check the superscript in the font, and then enter the inserted reference afterwards. 6. Double-click "1" in front of the reference, and the cursor will return to the place where the reference was inserted in the article content, and continue to write the article. 7. Insert an endnote in the next place where you want to insert a reference according to the above method again, and a "2" will appear (Word has automatically sorted it for you), and continue to enter the reference to be inserted. 8. After all the references are cited, there is a short horizontal line in front of the first reference (only visible in page view). If a spread is referenced, there is still a long horizontal line in the spread, which cannot be deleted. This is the mark of the endnote. 9. Switch to normal view and select View-Footnote from the menu. At this point, the edit field of the endnote appears at the bottom. 10. Select "Endnote Delimiter" from the drop-down menu on the right side of the endnote, and a short horizontal line will appear. Select and delete it. 1 1. Select Endnote Continuation Delimiter from the drop-down menu. This is a long horizontal line. Select and delete it. 12. Switch back to page view, and reference insertion has been completed.