Hawk beak hook is characterized by thick hook strip, inward hook tip and short hook handle. Thick strips are not easy to deform, have certain tolerance, have many mesh holes for pressure bleaching and have good stability; When the hook tip retracts, it is not easy to be blunt, and once the fish is hooked, it is difficult to escape and it is not easy to hang the fish; The hook handle is short, which is convenient for the fish to suck into the mouth, and it is better to lift the hook instantly. It is a good hook for catching big fish, not suitable for fishing small fish. If it is used for fishing in Taiwan Province, it is suggested to clamp off the barbs with pliers, one is to protect the fish, and the other is to hang clothes for easy removal.

Eagle beak hook is a commonly used fishing gear for bottom fishing, which uses "mother-child bait". When fishing with a hook, the fish are attracted by the bait, but they can't reach it. At this time, the fish on the greedy bug had no choice but to eat the bait. So in the case of fish, fishing is faster, if it is used to catch big carp.

The effect is better. If you want to catch bream, crucian carp and other small fish, you can use small hook bait to eat the hook conveniently, and the catch is equally good. Let's talk about how to do the somersault hook. Firstly, prepare an iron plate (or lead plate) and a plexiglass plate with a diameter of about 8 cm and a thickness of about 2 mm.

Drill a small hole in the middle, and then drill seven or eight small holes along the edge of the iron plate, which should be evenly distributed to facilitate the hook. Then use a small screw with a slightly thick middle and threads at both ends to pass the two plates through the small hole in the middle, and tighten them with small nuts outside.

The distance between the two fixing plates is about 2 cm. Tie the main wire to the screw exposed on the plexiglass plate. Then hang a hook on each hole on the edge of the iron plate, and the length of the hook line is about 6 cm. The main line of the turnover hook should use 0.6 mm or thicker nylon thread, and the hook traveling line should use 0.4 mm or thicker.

Use a hook with a body width of 10 mm to fix the bottom or the olecranon hook, without lead drop. The bait of the flip hook can be mixed with bean curd powder or bean cake with corn flour, which is sticky and not easy to foam. After the bait is ready, put it in the gap between the two disks, and be careful not to fill it too full, so that the big fish can't eat it and can only eat the bait.

This bait can be used to catch carp, carp pasta, or earthworm, red worm and so on. When it is used to catch carp, bait is not needed, but the hook line should be short and thick nylon line, so that the hook can be hung upside down on the edge of the gap between the two boards. In this way, carp can only eat hook bait to remove obstacles first.